• <optgroup id="jwrdj"></optgroup>

  • <span id="jwrdj"></span>
    <optgroup id="jwrdj"><li id="jwrdj"><source id="jwrdj"></source></li></optgroup>

    <span id="jwrdj"><output id="jwrdj"></output></span><acronym id="jwrdj"></acronym>
    <strong id="jwrdj"></strong>
    LG vacuuum pump
    LG vacuuum pump
    Sliding vane rotary vacuuum pump
    2X Sliding vane rotary vacuuum pump
    XD Sliding vane rotary vacuuum pump
    Water ring vacuuum pump
    2SK Two-stage Water ring vacuuum pump
    SK Water ring vacuuum pump
    SZ Water ring vacuuum pump
    2BE Water ring vacuuum pump
    Piston vacuuum pump
    WLW Oil-free vertical Piston vacuuum pump
    Roots vacuuum pump
    ZJ Roots vacuuum pump
    System
    JZJS Roots vacuuum pump System
    JZJX Roots vacuuum pump System
    JZJW Roots vacuuum pump System
    J2SK JSK J2BE Closed cycle System
    Blow Molding Machine
    YX1200 Large hollow blow molding Machine
    WUXI CITY SIFANG VACUUM EQUIPMENT CO.,LTD.
    WEB:http://www.jessicakmiec.com
    E-MAIL:sfpumps@163.com
    TEL:0510-85990421 85990035
    FAX:0510-85993842
    ADD:No.48 Changkang Road, Mashan, Binhu District, Wuxi
     
    Products
    Contents brief introduction
    XDSeries

    Sliding vane rotary vacuum pumps

            

      Instruction of working principle of sliding vane rotary vacuum pumps
    The functional diagram of rotating vane pumps is shown in the figure. The rotating vane pump mainly consists of the stator, rotor, rotary vane, fixed cover, spring and components. The structure is formed by rotor which eccentricly installed in the chamber of the stator (the outer circle of the stator is tangental to the inner surface of rotor, and the gap between the two is very small) and the two rotary vanes which adhere to the inner wall of the stator with the assistance of spring tension and centrifugal force and slide in the rotor slot, and when the rotor rotating, the two rotary vanes are always sliding along the inner wall of the stator.

    The two rotary vanes divide the crescent-shape space formed by surrounding by the rotor, chamber of stator and fixed cover into three parts A, B and C.

        
     
     When the rotor rotating by the direction shown in the figure, the capacity of space A, which is connected to the air entry, continuously increases, and the pressure in space A continuously gets down. When the pressure in space A is lower than that in the container in which the gas is pumped, according to the principle of gas pressure balance, the pumped gas is continuously drawn into the suction chamber A, that is the pump is in
    the process of suction. At this time, the capacity of the space of chamber B is gradually reduced, the pressure continuously increases, that is the pump is in the process of compression. With the capacity of space C which is connected with the air outlet is further reduces, the pressure in space C further increases. When the gas pressure is higher than the exhaust pressure, the compressed gas opens the exhaust valve, and the pumped gas continuously pass through the oil layer of the oil tank to the atmosphere. In the continuous running of the pump, it continuously repeats the process of suction, compression, and exhaust, so as to achieve continuous pumping.

    The exhaust valve is immersed in the oil to prevent air flowing into the pump. The oil gets into the pump chamber through the gap on the pump body, oil hole and the exhaust valve, to cover the moving surfaces in the chamber and form the seal of the suction chamber and exhaust chamber; in addition, the oil also full up all the harmful space to remove their impact on the ultimate vacuum.
    Two-stage sliding vane rotary vacuum pump consists of two working chambers which are connected in series and rotating at the same speed by the same direction. ChamberⅠis at a low vacuum level, while chamber is at a high vacuum level. The pumped gas enters chamber through  the air inlet. When the intake gas pressure is higher, the gas will be compressed in chamber , so that the pressure rapid increases, and the compressed gas will be not only exhausted from the senior exhaust valve, but also pass through the passage of the intermediate wall and enter chamber ,  then be compressed in chamber and exhausted from the low-level exhaust valve; when the pressure of the gas entering chamber Ⅰis low, despite the gas is compressed in chamber Ⅰ, it still can not open the senior exhaust alue to get out. All the gas enters chamber Ⅰ through the passage of the intermediate wall, and by compressed in chamber Ⅰ, it is exhausted from the low-level exhaust valve. Therefore, the ultimate vacuum of the two-stage sliding vane rotary vacuum pump is higher than that of the single-stage sliding vane rotary vacuum pump.

    Range of use


        XD pumps are widely applied to the vacuum packaging of various types of food, paper conveying in printing industry, vacuum suction molding in rubber and plastic industry, vacuum impregnation treatment of various castings, vacuum fixture of engineering industry, vacuum suction in surgeries of hospitals, vacuum power test, etc.

    Performances and specifications


     Function Model

    (m3/h)
    Pumping Speed

    ≤(Pa)
    Ultimate
    Pressure

    (kw) Motor Power


    (rpm)
    Rotational
    Speed


    (L)
    Injection
    Amount`of Oil

     (in)
    Inlet
    Diameter

    (Kg)
    Weight


    dB(A) ≤

    XD-010

    10

    200

    0.37

    1400

    0.5

    G1/2"

    16

    69

    XD-020

    20

    200

    0.75

    2800

    0.5

    G1/2"

    18

    71

    XD-040

    40

    200

    1.5

    1440

    1.5

    G11/4"

    58

    75

    XD-063

    63

    200

    1.5

    1440

    2

    G11/4"

    62

    76

    XD-100

    100

    200

    3

    1440

    2.5

    G11/4"

    89

    77

    XD-160

    160

    200

    4

    1440

    9

    G2

    145

    79

    XD-250

    250

    200

    7.5

    1440

    9

    G2

    200

    80


       

    Installing dimension drawing


    Type 

    A

    B

    C

    D

    E

    F

    XD-010

    405

    265

    210

    60

    210

    131

    XD-020

    430

    265

    210

    60

    210

    131

    XD-040

    624

    312

    280

    160

    315

    183

    XD-063

    665

    330

    280

    130

    364

    195

    XD-100

    725

    470

    255

    211

    352

    275

    XD-160

    835

    540

    410

    240

    390

    304

    XD-250

    948

    540

    410

    240

    516

    304


    Characteristic curve


     
    久久视频

    All rights reserved:Wuxi City Sefang Vacuum Equipment Co.,Ltd         
    Add:No.48 Changkang Road, Mashan, Binhu District, Wuxi Tel:0510-85990421 85990035
    Technical Support:wxmilai.com 蘇ICP備:0510548號